Steel Seal SSAMZ Head Gasket Repair – Pour In Engine Head Gasket Sealer for Water Cooling Systems – Works with All Blue Antifreeze Types – Cars, Vans, 4x4s, Trucks & Motorbikes

Well well well ... Fixed my daughter's Citroen C1. It was missfiring in the morning, losing water and engine light on with cylinder 3 miss-fire. Replaced the plugs and swapped coil pack, still cylinder 3 was the issue so knew either the head or gasket had gone. FOLLOW THE PROCESS! Its been a month now and still holding firm, so far so good.

30 years a mechanic.. this actually works compared to other manufacturers.

This was a waste of money, did not work and i followed the instructions to the letter, to make sure, i checked the steal seal website and read the actual instructions, which advise taken out the spark plugs one by one to identify the culprit. Flushed the coolant 3 times before adding sealant and ran for 30 mins when temp reached 90 degrees. Left it overnight for a whole 24 hours and next day ran again for 30 mins but right at end started bubbling and overheating. Since then flushed it several times, which was a pain to get rid of all this sealant and even now with distilled water added it is still overheating. Gist is; if you have a head gasket issue, then there is no choice but to strip the engine and clean it and replace the gasket. This will now be my next plan, just wished i get my money back but this seller simply states follow the claim procedure on the bottle, and that is steal seal requires a mechanical reciept advising head gasket failure or a scrap certificate. This mean forking out more money to a mechanic just to get your money back for this cr*p bottle of snake oil and that means the gaurantee is a lie.

Very good done the Job

I believe this worked because we followed the instructions to the letter - emptying the coolant system of every last drop of water contaminated with antifreeze. We used this in a 1.4 MG ZR. It was losing water (about a pint every 6 weeks), but not into the oilways nor any visible leaks, nor was it letting by to the point its pressurising the coolant system. Suspected headgasket beginning to seperate (common on the K series) and was told to try this before tearing down the engine. Hasn't lost a drop for months now. How good this would work on a badly blown/cracked engine is anyones guess, and we only gave it a go as the motor is 20 years old and it wouldn't have been the end of the world if it destroyed the motor. But in this instance it saved me either a lot of time repairing, or money getting somone else to do it, and my son didn't lose the car for a few weeks whilst being repaired. In summary, a good product that worked for me. Would I use in a modern car with complex cooloing systems/turbos etc that are worth lots of money, probably not. But in something on its last legs, to get you home or out of a fix, then I would use this over other similar products.

Think it may have slowed the leak, but lets face it there's no miracle cure for a blown gasket if it's too far gone. Can't say it worked completely, so can neither recommend or warn.

it worked. not right away but after a few cycles

Used in a rally and the car still going fine 10/10

Leak bottle

I flushed my system of old coolant prior to use, including my heater core and refilled with regular tap water along with the Steel Seal. I followed the instructions on the back of the bottle and the leak was fixed. I left over night, drained the next day, and refilled with coolant. I don’t drive the vehicle daily so I’m hoping the Steel Seal will last. It did work for me and I like that it won’t clog your radiator or cooling system.

Worked very well, had driven another 18k kms till now wothout any issues!

Este producto es.una estafa.no sirve para nada

Came highly recommended by a mechanic. Saved us an expensive fiddly hard to reach repair for a water leak. Hopefully does the trick. No complaints so far. Worth a try for the cost.