Garbage fighter Tires for Series 500, 600, 700, 800 and 900, e5, e6, i7,Anti-Slip, Great Adhesion and Easy Assembly, Wheel Replacement for All roomba Models (Black 2 Pack)

Got these for the Roomba that does the tile floors. Works exceptionally well. No slip and grips the floor well. Easy to replace.

After searching online for why my Roomba couldn't climb the shallow slope to its charger, I discovered that Roombas have tires for their little wheels. These tires fit multiple models. Getting the old tires off was a pain as it appears the original wheels for the model I have, are integrated with the tires. After finally dissecting the old tires away where the rubber was attached inside the wheels, the old tires came off. Putting on the new tires wasn't all that difficult and I have arthritic hands. Haven't tried to remove the new tires but adjusting them to fit perfectly was easy and the same method can be used for removal.

Worked well as replacements for original, hard part was getting the old ones off since they have "nubs" that insert in holes around wheel. Heated water and out the new tires in for a few minutes and they slipped right on.

I picked these up for $10 rather than going through iRobot as they make you replace both wheel modules. Installation was simple. 1: Unscrew bottom plate by removing 5 screws (See picture) 2: Identify the wheel modules, and the two gold screws attaching each. I could see this being a difficult step if you do not have the right equipment, as the phillips heads were small. 3: Remove the four gold screws. Modules should lift without resistance. I was able to remove the modules without completely removing the screws that were in the deeper holes. 4: Use something (I used needle nose pliers, but I imagine a flathead screwdriver might have been easier) to remove the old tires. I pulled from the lip, and then once I was able to get my pliers underneath the rubber, I slowly worked the tires off. I let my roomba run before I did this job, and because the rubber was still warm, I think it was easier than it would be if they were cold. You will probably end up pulling them off in pieces because the OEM tires are anchored in the plastic wheel. Its ok if bits of rubber get stuck in the insertion points. That will only act as additional friction for the new tires to grip. 5: Attach the new tires. This was the easiest and most satisfying part of the job for me. I attached the tires by getting half of the tire on the top, then turning the wheel so the seated portion was on the bottom, then worked the other half on. Make sure the interior rib of the new tire sits properly in the channel of the wheel. 6: Reassemble. I used a Phillips #2 for the exterior screws, and a Phillips #1 for the interior screws. This was absolutely worth the money. Gone are the days of my roomba not being able to get on the dock properly, or just turning wheels at a threshold. I gave 5 stars but I would give 10 if Amazon allowed it.

Putting the tires on was tricky, but more tricky was getting the spring attached back. I used a thread to pull it back into place. Took maybe 30 mins overall but works brilliantly for s9+. It has stopped docking and would get stuck when returning to station with wheels rotating but replacing the tire fixed it.

This is not a simple task for the average DIYer to remove old tires and replace with new. I have an older Roomba (983) from Costco and the tires were molded on to the Roomba's wheels. yes they do work but it will take you at least a couple hours to replace them. however they will work

Good

No detail instructions were included.

Muy buen producto a muy buen precio

Recibí un día antes de lo esperado el producto, se ven de buena calidad están funcionando adecuadamente

Duraderas, similares o iguales a las originales.