MICRO LRP MOUNT KIT

I recently bought an H-1 Micro without looking too closely at the details. I brought it home to find that it comes built for Weaver rails rather than Picatinny like my rifle has. I was a little hesitant about ordering this because I couldn't find any information on it, but I went ahead and took the chance. I'm writing this review mostly to help people doing the same as I am. This mount, while officially made for a T-1, will fit perfectly on an Micro H-1 and allow it to be mounted to a picatinny rail, with the added bonus of having a quick release handle. Once it is attached correctly it is as snug a fit as you would like and easily detaches with the release lever. Just pay attention to the instructions or you'll waste half an hour trying to put it on backwards like I did, and be aware that there are two tiny springs that come in the baggy that I almost lost because I didn't know they were there til I saw them mentioned in the instructions.

I have two Micro aim-points, one came with this quick release, and has always worked flawlessly. The Conversion, I had to file the pin down to make it so it works as intended, So if you have issue with it not allowing you to get it to come off fully from the rail, you may have to do what I did, check out the pictures. It is a pretty simple fix. It now works as my other. I don't believe there is any reason to over tighten the nut either, mine clip on and off, with little effort and don't lose zero. I'd have given it 5 Stars if I didn't have to mess with it.

Ordered this on September 6 received quickly. Installed it on my Aimpoint H-1. I went to the range and zeroed the sight. I went to remove the sight and the arm snapped off right at the hinged pivot point. Upon close inspection it appears the arm is a very soft aluminum and there is very thin areas at the pivot point which is where the arm broke. Also the arm does not release the mount completely from the rail and you will have to unscrew by hand the threaded nut to get the sight off of the rail. Sad, $40 down the drain.

Got this for the Sig Romeo 5. It would not work with the mount.

Solid lock up. Repeatable zero. Mount didn't budge. Used it on a red dot sight mount on an AK gas tube rail with barrel bands. I couldn't be happier.

This one is slightly different from one I purchased a few years ago. Apparently there was a design change. Seems to work well and mounts the sight up solidly enough.

Maybe its a fake ... When the item came to my surprise it did not come with the correct parts It was missing the springs and the nut at the end to hold it into place. It did come with a very suspect end nut tho, but nothing that looks like in the pic on amazon or on the Aimpoint website.