Versachem Muffler Weld Repair & Sealer, 6.0oz

Very happy with this purchase. Clearly from the reviews, consistency varies. I had a can previously that had been stored on the shelf for about a year, and was hard as a rock when opened. The new can I purchased on Amazon was a perfect clay consistency, not too runny or hard, very easy to work with. I used it to hold in a pipe that was popping out of it’s socket and causing my car to run loudly. I let it sit for 48 hours, and have been driving with it for about 2 weeks; it’s so far held up perfectly. I generally don’t drive more than a couple of miles at a time, so I can’t speak to longer distances, but for what I need, it’s definitely done the trick! Edit: it’s now been about 3 months and the repair is still holding up!

Depending upon the exact location of any hole in the exhaust and the size of the hole, this is a good low cost alternative to replacing a pipe. It is not going to last forever, but it lasts a few months for me before I have to reapply it. It goes on like soft clay and hardens in about ten hours. If you want to let the car idle, it will cure in ten minutes. It becomes quite hard, but brittle, so unless it is supported and reinforced with some kind of muffler tape, the hole will reopen when the putty cracks.

The repair shop wanted $2900 to replace my entire exhaust system I drive a 2009 Chrysler Aspen SUV and I don’t think it’s worth $2900 if I were to sell it. I’m a 70 year-old woman, and I easily get under the car and patch the holes in the muffler! Instructions were easy, and now my car runs much quieter. Great product. Lasts me about 6 months and then I buy patch again. Well worth it!

I gave one star because I couldn’t do -10 stars. This product is trash does not work! Every time it rains it turns to mush and rubs off like mud. Stay away from this product DO NOT waste your money.

It makes a seal but didn’t last long enough for it to be worth it.

Product arrived New not opened twist plastic cane. Repair Place rear muffler/ resonator welding area (VW) welding material chip product. Relative difficult area to access and applied product : Zero assembly required. Product applied on top of muffler entire side 3-4 mm thickness; after 1 Hour product settles down to Smud application 2-3 mm tick 3 cm wide and 40 cm long strip on top of muffler hand touch reedy . I will recommend to order two cans and applied to entire veld surface to bi Shure and save min 500$ for other repair. Update 11/15/22: Application applied in Jun and still holding no cracks.

I used this in conjunction with Tiger Patch. I had an exhaust pipe that had broken apart. I wired each part to prevent movement. Then applied this - there was literally about a quarter inch gap, which this filled easily. I made sure it was smooth. I then alternated heavy duty aluminum foil with a coating of this product. I did this a number of times. I then wrapped this with Tiger Patch - I then coated the Tiger Patch with this. I did this over a weekend to allow time to cure.

Good stuff but use it up or it’ll dry out on you. Plan a few repairs my advice.

, excellent product you don’t need r go to the garage but it take 48 h to dry completely and sounds disepear Muffler voiture arrière trouver

Time will tell , muffler seam corroded used to cover and seal seam, use generously , still standing, been two weeks

It's Incredible! After use this product, the muffler works like a new one.