2 Pcs 18lb /80N Hydraulic Gas Strut Lift Support Cabinet Hinge Kitchen Cupboard Door Gas Spring Door Shocks Cabinets Hinges

I used these lift supports to hold up my custom arcade cabinet control panel. I initially tried higher rated gas struts, but those exerted too much pressure and only one would not allow the panel to stay close. This 18lb rating was just fine for my control panel which weighs around 30lbs (plywood, acrylic, and arcade controls). The metal band clips make it easy to pop off the mounting points by simply slipping a flathead screwdriver underneath, to make installation or swapping out the mounting points easy. They hold the lid up and slow the rate of closure, though they're not a "soft-close" type, maybe in a different setup the struts can be positioned well enough to allow for that.

Works great on my Intech Rover. Easy to follow instructions, is best to drill small starter holes. Otherwise, I just screwed In directly.

I couldn't find the size I wanted for my RV cabinets so I went with these. There is nothing wrong with them, but know they are powerful arms. I put one on my cabinet and closing it blew out the wood it was screwed in to. My bad. They're good and I missed ordering the wrong application. Well made but strong pressure.

This item was a replacement for a furniture strut and had matching information for size and load. Was a breeze to change and it works beautifully now.

Good quality and essy to install

This was mounted on a window seat that we store toys in for the grandkids. The lid is 3/4 ply would and should weigh about 28 lbs. I installed only 1 cylinder. The cylinder overall length is 7 inches retracted and 10.5 inches fully extended. The eye to eye spacing is 6 (152/4 mm) retracted and 9 5/8 inch (244.5 mm) fully extended. I like the concept however no instructions came with my set. There is a small diagram on the Amazon sales ad page that shows mounting these at Y= 90mm and X =280 mm center to center for a 90 degree opening. If you figure the hypotenuse of that it would require 294 mm cylinder length eye to eye hole but extended the cylinder is only 244.5 mm eye to eye, and this is ignoring the 24.5 mm offset to mount the fixed piece. I did mount mine with Y=90 mm X about 260 mm so the door isn't quite at 90 degrees when open but it does stay open. That's why I only used the 1 cylinder since the piston doesn't really do anything as you approach 20 degrees. The lid will still slam shut as it gets close to closed since the piston is then fully retracted and it is just rotating on the fixed mounts but not quite as hard as if you had nothing. So overall these only partially solved my problem, the lid will stay open however it still shuts to fast if you let it go when closing.

Only got 4 Struts instead of 5!!!!

These hinges work well for my kitchen cabinets. I thought they were a lot more expensive so I'm glad these were so affordable, I just hope they last. They were easy to install despite not receiving a manual as stated in the description. I will be buying more to finish the rest of my cabinets.

منتج جيدا وجميل وسهل التركيب

يعمل بشكل جيد

كويسه جدا بس جاي من غير مسامير الاوردر الاولاني كان فيه مسامير

جيدة

As expected